MAN TGX 26.480 - Tiong Woon
This sharp MAN TGX 26.480 belongs to Tiong Woon from Singapore (SG) and stood with some heavy cargo parked along the road. The combination exists out of a 3-axle ballasted truck with a 12-axle modular trailer.
The truck is this MAN TGX 26.480 with 6x4-drive. The truck is powered by a MAN D2676, a 12.8-litre 6-cylinder diesel engine with a power of 353 kW (480 hp).
Behind the front axle is the diesel tank mounted.
On top of the driven rear axles is a ballast box mounted to give enough pressure on the driven rear axles.
On this side are the muffler, battery, two compressed-air tanks and a smaller storage compartment installed behind the front axle.
Towed is a 12-axle Goldhofer THP/SL 6 platform trailer. The trailer is composed out of two 6-axle modules.
The cargo is a Menck MHU 1200S hydraulic hammer with a total mass of approx. 149 tonnes.
Around 10:00 PM is the transport allowed to move to the other port. A very sharp transport done by Tiong Woon!
A couple of days later I found the truck again doing some oversized transport, here was a long concrete beam transported.
The beam is 40 meters long and weights 75 tonnes.
The beam is loaded on two old Cometto modules, in front on a five-axle module and at the back on a 4-axle module. On the modules are turn tables mounted so that the cargo can rotate against the trailer.
A few moments later is the beam getting unloaded by the Demag CC 2800 of Yew Choon.
Here was the sharp MAN TGX 26.480 of Tiong Woon from Singapore (SG) used for the transport of a heavy Menck MHU1200S hydraulic hammer.
Attached is a 10-axle Cometto modular trailer which is composed out of two five-axle modules.
The hammer is approx. 14.3 meters long and weights about 120 tonnes with transport struts.
A very sharp transport by Tiong Woon!